Difference between revisions of "X10 Antenna Configuration"

From GrandCare Systems
Jump to navigation Jump to search
Line 17: Line 17:
* If installed correctly, the row will now be highlighted in green. If there is a problem with the installation, the row will be highlighted in red.
* If installed correctly, the row will now be highlighted in green. If there is a problem with the installation, the row will be highlighted in red.
* After it is installed correctly, you can begin to [[Z-Wave Devices|add Z-Wave devices]], such as motion sensors, door sensors, etc.<br /><br />
* After it is installed correctly, you can begin to [[Z-Wave Devices|add Z-Wave devices]], such as motion sensors, door sensors, etc.<br /><br />
At the touchscreen (or for a CoMo box - at the GCTV image)
Click the System Icon    (if needed - default PIN is 1111)
Click Peripherals
W800 is X10
Choose the port
Click “Turn On”
Restart peripherals when prompted

Revision as of 18:56, 2 August 2012

Z-Stick
Peripherals Screen
Choose a Port


Overview

When you are using Z-Wave protocol ADL sensors, you have your choice of two Z-Wave transceivers (antennas), the Z-Stick or the Z-Troller. The Z-Stick is more commonly used, because of its small form factor. It is also easy to use, and less expensive than the Z-Troller. The Z-Stick has a shorter range than the Z-Troller, and is appropriate for demo systems, apartments, and smaller houses.

How to Install a Z-Stick

At the touchscreen (or for a CoMo box - at the GCTV image):

  • Insert the Z-Stick into an available USB port (typically a port on the back of the machine, ideally a lower port, so that smaller USB devices will be visible above the Z-Stick)
  • Press the System (Gear) button
  • Enter the 4-digit System PIN (which is set, and can be viewed, on the Advanced Settings screen in the Care Menu)
  • Press "Peripherals"
  • Choose the antenna type (Aeon Labs Z-Stick)
  • Choose the port - your choices will be specific to the system hardware
  • Press "Turn On"
  • Restart peripherals when prompted
  • If installed correctly, the row will now be highlighted in green. If there is a problem with the installation, the row will be highlighted in red.
  • After it is installed correctly, you can begin to add Z-Wave devices, such as motion sensors, door sensors, etc.


At the touchscreen (or for a CoMo box - at the GCTV image) Click the System Icon (if needed - default PIN is 1111) Click Peripherals W800 is X10 Choose the port Click “Turn On” Restart peripherals when prompted