Difference between revisions of "Z-Stick Configuration"

From GrandCare Systems
Jump to navigation Jump to search
 
(3 intermediate revisions by 2 users not shown)
Line 1: Line 1:
[[thumb]]
[[File:ZStick.png|thumb|right|Z-Stick]]
[[File:PeripheralsScreenForZ-Stick.png|right|frame|Peripherals Screen]]
[[File:PeripheralsScreenForZ-Stick.png|right|frame|Peripherals Screen]]
[[File:Z-WavePorts.png|right|frame|Choose a Port]]
[[File:Z-WavePorts.png|right|frame|Choose a Port]]
===Overview===
===Overview===
When you are using Z-Wave protocol ADL sensors, you have your choice of two Z-Wave transceivers (antennas), the Z-Stick or the older [[Z-Troller Configuration|Z-Troller]]. The Z-Stick is more commonly used, because of its small form factor. It is also easy to use, and less expensive than the Z-Troller. The Z-Stick has a shorter range than the Z-Troller, and is appropriate for demo systems, apartments, and smaller houses.<br /><br />
When you are using Z-Wave protocol ADL sensors, you must first set up the Z-Wave antenna, the Z-Stick.<br /><br />


===How to Install a Z-Stick===
===How to Install a Z-Stick===
Line 10: Line 10:
* Press the System (Gear) button
* Press the System (Gear) button
* Enter the 4-digit System PIN (which is set, and can be viewed, on the Advanced Settings screen in the [[Care Menu|Care Menu]])
* Enter the 4-digit System PIN (which is set, and can be viewed, on the Advanced Settings screen in the [[Care Menu|Care Menu]])
* Press "Peripherals"
* Press "Devices" and then "Antennas."
* Choose the antenna type (Aeon Labs Z-Stick)
* Choose the antenna type (Aeon Labs Z-Stick)
* Choose the port - your choices will be specific to the system hardware
* Choose the port - your choices will be specific to the system hardware

Latest revision as of 21:24, 13 March 2019

Z-Stick
Peripherals Screen
Choose a Port

Overview

When you are using Z-Wave protocol ADL sensors, you must first set up the Z-Wave antenna, the Z-Stick.

How to Install a Z-Stick

At the touchscreen:

  • Insert the Z-Stick into an available USB port (typically a port on the back of the machine, ideally a lower port, so that smaller USB devices will be visible above the Z-Stick)
  • Press the System (Gear) button
  • Enter the 4-digit System PIN (which is set, and can be viewed, on the Advanced Settings screen in the Care Menu)
  • Press "Devices" and then "Antennas."
  • Choose the antenna type (Aeon Labs Z-Stick)
  • Choose the port - your choices will be specific to the system hardware
  • Press "Turn On"
  • Restart peripherals when prompted
  • If installed correctly, the row will now be highlighted in green. If there is a problem with the installation, the row will be highlighted in red.
  • After it is installed correctly, you can begin to add Z-Wave devices, such as motion sensors, door sensors, etc.