Difference between revisions of "Z-Stick Configuration"

From GrandCare Systems
Jump to navigation Jump to search
Line 3: Line 3:
[[File:Z-WavePorts.png|right|frame|Choose a Port]]
[[File:Z-WavePorts.png|right|frame|Choose a Port]]
===Overview===
===Overview===
When you are using Z-Wave protocol ADL sensors, you must first set up the Z-Wave transceivers antennas, the Z-Stick.<br /><br />
When you are using Z-Wave protocol ADL sensors, you must first set up the Z-Wave antenna, the Z-Stick.<br /><br />


===How to Install a Z-Stick===
===How to Install a Z-Stick===

Revision as of 22:04, 6 December 2018

Z-Stick
Peripherals Screen
Choose a Port

Overview

When you are using Z-Wave protocol ADL sensors, you must first set up the Z-Wave antenna, the Z-Stick.

How to Install a Z-Stick

At the touchscreen:

  • Insert the Z-Stick into an available USB port (typically a port on the back of the machine, ideally a lower port, so that smaller USB devices will be visible above the Z-Stick)
  • Press the System (Gear) button
  • Enter the 4-digit System PIN (which is set, and can be viewed, on the Advanced Settings screen in the Care Menu)
  • Press "Peripherals"
  • Choose the antenna type (Aeon Labs Z-Stick)
  • Choose the port - your choices will be specific to the system hardware
  • Press "Turn On"
  • Restart peripherals when prompted
  • If installed correctly, the row will now be highlighted in green. If there is a problem with the installation, the row will be highlighted in red.
  • After it is installed correctly, you can begin to add Z-Wave devices, such as motion sensors, door sensors, etc.